NavKal
NavKal is an Electronic Control Module (ECM) Programming Software that replaces all previous PC based ECM Programming Software (Nets, AutoUpgrade).
Software Features:
* Offline Calibration updating
* Parameter and Horse Power changes
* Program a Blank Module
* On-screen display of vehicle information, Including ECM software Version and Upgrade availability
* Read and Clear Engine DTCs
* Create Programming Verification Code (PVC)
Requirements:
* Supported EZ-Tech (Win XP or later)
* RP1210B diagnostic interface cable and latest supported drivers
Used to repair airbags (delete collision data), create new dump files for airbags if you lost the original. Disabling IMMO and preparing IMMO dumps for snapping, decoding radio, repair manual for VP Pomp. The software can calculate the pin code for BSI and ECU.
In this software there are more than 3500 algorithms. The program works with BIN files, so you can use any memory programmer.
Installation: Install the program, then extract the license files from the archive to the root of the installed program. If swearing on the path to the photo, just copy the foto folder to the root of the C:
How to check version boot loader, firmware, diag. software, production date LAUNCH EasyDiag / M-Diag / Golo EasyDiag / Diagun III / X431 Pro / X431 Pro3 / X431 Pro3S / DBSCar without official software
.png "Cat"){kind=icon}
![[Image: 7f7dfd9ff322.png]](https://b.radikal.ru/b21/1803/23/7f7dfd9ff322.png)
